how to install berber carpet
how to install berber carpet
how to install berber carpet::Colors and prints can be easily adapted to fit the design scheme of any room.What you will need for this project: steps to follow: measure the length of each wall and divide the length by two.
Mark this midpoint with a pencil.
Find the center of the room by these four mid points.
You will need to do this so that you can ensure that the carpet tiles will lie properly and that you end up with a single tile in the center of the room.
Center one carpet tile measure the width of the center tile that you will be using and divide it by two.
This will give you the center of the tile.
Install the first carpet tile in the middle and work out from that center tile.
Use the colored tiles to create a pattern.
Because you have not attached them to the floor, you can pull them up and change the pattern as often as you like until you are happy with it.
Once you have decided on the pattern, remove the covering from the tiles and stick into place.
Cut the carpet tiles to fit against the walls.
Before installing the last tiles against the wall, turn them upside down and set them against the wall and mark where the carpet square overlaps against the wall.
Use a straight edge and a sharp exacto knife to make a straight cut on the underside of the carpet tile.
Install this cut tile with the rough edge against the baseboard.
how to install berber carpet::Vacuum the old carpet, so that any dust
on it does not cause you problems while you remove it how to install
berber carpet
Комментариев нет:
Отправить комментарий